The Proof is in the Gloop!

3D Gloop! is not your normal adhesive... It took many iterations and a lot of science to finally put an end to some of the most frustrating issues with 3D printing.

We know once you try 3D Gloop!, your 3D printing experience will never be the same! - And that's a good thing!

Warping is a Thing of the Past

With 3D Gloop! Warping is a thing of the past. The unique adhesive formula bonds ABS and PLA firmly to glass, metal, even painters and polyamide taped build plates without expensive upgrades, heated build chambers, or rafts required! 

3D Gloop! is easily brushed onto the build surface of your printer just before it's time to print. A uniform coating over the area just a bit bigger than your intended print is all that is needed. Put up to 3 layers down to ensure a super strong hold! 

*That said, our Gloop is made of science, not magic. If you are attempting tall, large prints, and try to print in drafty environments, your higher layers could still separate and curl, but your bottom layers never will.  

Once your print is finished, all you have to do is work a scraper/spatula under the print to break it free. Alternatively, if you're headed to bed, you can wait for your print to cool and generally a simple twisting motion will free your print from the build plate.  

When your're ready to print again a sharp putty knife or scraper peels away the unused gloop easily and effortlessly. 

Enabling Far-Reaching Creativity

Large format 3D printers are quite simply the future of the industry. However, one of the downsides of most reasonably priced large format printers is their typical lack of a heated build chamber. This means that printing materials like ABS is an incredibly hard task without upgrading key components on your printer... 

3D Gloop! enables printers such as the CR-10s, LulzBot, Prusa Printers, and others alike to print in ABS without the need for expensive added upgrades.

Now we're not talking about turning your printer into a fire hazard by enclosing it in makeshift enclosure, keeping a space heater close by, or pointing heating lamps on your print. 3D Gloop! makes printing in ABS easier on these stock printers than ever before due to its incredible holding strength.

Printing ABS at Room Temperatures - What???

You still don't believe 3D Gloop! is remarkable?

We all know printing ABS is a pain. Let alone ABS on an open form factor printer. 

As we mentioned before, 3D Gloop! can not only enable printing great ABS prints on a stock CR-10s. It can even do it with a room temperature build plate... (heating the build plate some increases consistency of sucessful prints)

That's right... 3D Gloop! remarkably enables the printing of ABS filaments on open form factor 3D printers with cold build plates. 

Every printer is different, as well as the models they print. For best results, we still recommend a heated build platform for most models, but again, the proof is in the Gloop!